Maybe late to the table but I hope this info can help someone that is experiencing trouble on an R720. You might want to examine your BIOS settings where it concerns power management. Where I work we run thousands of R720s and therefore have seen this quite a bit. Please refer to Dells...
Debian, Ubuntu and Redhat all did two releases to address the issue. If you have applied an update in the last 24 hours then you should be in good shape.
I wasn't aware of an exploit in the wild that targeted anything beyond apache. Is there such a beast or was Proxmox vulnerable in any of...
Just a question to the OP. If you were running Freenas, was the data in question stored on ZFS? If so, were snapshots enabled? You might be able to roll back and recover if so.
Any live cd will do the trick. Boot it and mount your /dev/sdX (X being the drive that the machine boots from and is usually sda). eg mount /dev/sda /mnt
CD into the mountpoint. eg cd /mnt
cd into the etc directory. eg cd etc (you can combine the two steps into cd /mnt/etc)
type in pico...
Several things come to mind. Have you thought about using CIFS shares to:
create a semaphore (if file exists do this command then delete the file)
create a drop file (if file exists open it and do what it says then delete it)
look into running your scripts via a service then use net rpc...
Several things come to mind. Have you thought about using CIFS shares to:
create a semaphore (if file exists do this command then delete the file)
create a drop file (if file exists open it and do what it says then delete it)
look into running your scripts via a service then use net rpc...
I haven't done this but looking at it, doesn't your iscsi targets reside on a zfs volume? If it does, couldn't you just create a snapshot routine and then replicate from one freenas to the other (I assume you are using the same nas type)?
Re: Hardware Recommendation / Raid controller with operational web interface on proxm
I run 2 High Point 4320 using SATA drives. It supports SAS also. It has a separate ethernet port and is web accessible. I have been using these for 2 years without issue.
I should have included that if you are in production and need access to the desktop of the Zentyal machine ( I can get what I need done with ssh and the web interface) you can install X2go or similar. The screen does not flicker on this type of remote terminal.
A common problem in the 2.X series of Zentyal. Either remove LXDE and use Gnome or something else. The problem is cured in the 3.X series so if you are still setting up and not in production yet, I suggest you install Zentyal 3.02 instead. It does the same thing under Xen or plain vanilla...
Back up the VM first. re-size the lvm volume. Expand the VM filesystem using resize2fs within the running VM. Straight forward and easy. Don't skip backing it up first or you may lose data. All of this is assuming a linux VM. It is similar for WinXX machines.
To clarify maybe, LVM is a good thing to store your virtual machines on. Using lvm inside your virtual machines may have some performance penalties in my opinion but it DOES work. Using LVM to store a virtual machine improves performance.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.