Recent content by garyatokc

I never could get the process to work, so i had to build each of the images from scratch again in Proxmox. But then I had problems getting the VLAN setup to work so i switched away from Proxmox. Sorry i Couldn't be more help.

I was able to fix my problem by doing the following. # network interface settings auto lo iface lo inet loopback iface eth0 inet manual iface eth1 inet manual iface eth2 inet manual iface eth3 inet manual auto eth4 iface eth4 inet manual auto eth4.1 iface eth4.1 inet manual auto eth4.10...

PUtting a gateway in each subnet (bridge) seemed to have solved the connectivity issues but I still can not put more then one trunked interface in otherwise i continually get an error vmbrx: recieved packet with own address as source address. here is my current interfaces file # network...

i have a iScsi interface to a SAN and i also have it bridged to the VIrtual machines so that they can access the volumes on the SAN. I have two different ip set, one for the four slaved interfaces for proxmox access to the iscsi storage and one for the vmbr for the virtual machines. Bond0 is...

rwems-610-03:~# ip a | more 1: lo: <LOOPBACK,UP,LOWER_UP> mtu 16436 qdisc noqueue state UNKNOWN link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00 inet 127.0.0.1/8 scope host lo inet6 ::1/128 scope host valid_lft forever preferred_lft forever 2: eth0...

proxmox version is 1.7

I have Six Servers I am trying to setup to use vlan trunking to the Guest machines. I have one Bond interface for an iScsi SAN using Eth0-3, i have one NIC that is on the management Network, 15 (10.20.15.0/24) setup to vmbr0, then i have two nic cards setup in a bond1 (eth4 -5) that I want to...

I have followed the guide and created the single growable file, on a Windows 7 machine running VMWorkstation v7.1, then i have coped the resultant file to the ProxMox Machine, renmaed it to match what the virtual machine thinks the disk name should be, but then I get an error, "Error loading...